Anest Iwata 9233 HVLP Gravity Feed Spray Gun, AirGunsa 2.0 mm

  
Anest Iwata 9233 HVLP Gravity Feed Spray Gun, AirGunsa 2.0 mm. The Anest Iwata 9233 is a center-post gravity feed HVLP spray gun equipped with a 2.0 mm fluid nozzle and a 600 mL cup. It's designed for high solids primers, sealers, and coatings, offering a 14-inch spray pattern at 28 psi while drawing 12.0 CFM of air. 2.0 mm nozzle optimized for high solids primers, sealers, and surfacers (Selectum). Produces a 14-inch wide spray pattern at recommended settings. Soft trigger pull and ergonomic lighter body to reduce operator fatigue. Polished external surfaces for easier cleaning and maintenance. All wetted parts made from stainless or corrosion-resistant materials for durability.

Nozzle / Fluid Tip: 2.0 mm. Cup Capacity: 600 mL gravity feed. Recommended Inlet Pressure: 28 psi. Air Consumption: 12.0 CFM. Spray Pattern Width: 14 inch.

Wetted Materials: Stainless / polished surfaces for durability. System Compatibility: Suitable for HVLP spraying of high solids primers, surfacers, sealers, and filler materials in automotive refinishing and industrial coating environments. Quantity: Single spray gun with 600 mL cup. The Anest Iwata 9233 spray gun is also referred to as AirGunsa 2.0 mm HVLP gun, AZ3HV2-20G gun, Iwata 9233 primer gun, center-post gravity gun, and Iwata high solids spray gun. Q: What coatings are best applied with the 9233?

A: Its 2.0 mm nozzle is ideal for high solids primers, sealers, and surfacers where a wide, consistent pattern and good material transfer are needed. Q: What air supply does it require? A: It's set to operate around 28 psi inlet pressure with approximately 12.0 CFM of airflow. Q: Can it accept 3M PPS cups?

A: Yes, It's compatible with 3M PPS cup systems (Type 43) in addition to the standard 600 mL gravity cup.